Page 4 - MENDERES KATALOG - ENG

BASIC SUGGESTIONS

ABOUT THE PRESSES

•Internal temperature of the
press must frequently be con-
trolled through electronic ther-
mometer or temperature meas-
uring papers.
•In the mornings, (especially in In this case, if the strength dif- by observing the behaviour of the
winter) when the presses are first ference disappears, it means that water that was dripped onto it. If
started, overall temperature in the problem is in press cylinders, the cloth slides the water rath-
the press may remain below the have it checked immediately. er than absorbing it, the liquid
optimum level even though ther- • You could also do this control, transfer is hard for this quality.
mometer, being fed by the resist- when the press is cold, by using As the application of the fusible
ance, indicates the right temper- white A4 size standard papers and interlining means to liquidize the
ature. In such case, differences an unused carbon paper. Place coat by using heat, and transfer it
may occur between applications the unused A4 size carbon paper to the cloth by using pressure; a
in the early mornings and after- between 2 white A4 size papers. cloth quality which has the resist-
wards. This is an important as- Compress the papers from the ance to absorb water will natural-
pect that must be paid attention in left, right and middle at the same ly behave in the same way when
terms of the quality of the prod- time. Observe the darkening ratio absorbing the liquidized coat of
uct. In order to avoid this prob- of the white papers by the carbon fusible interlining. As it could be
lem, no fusing should be done, for paper and see whether its marks grabbed from the above example,
at least 30 minutes after the press are different at the left, right and without being mistaken by the
is started. middle parts, or not. cloth similarities; necessary ad-
justments should be made on the
OBSERVING THE CLOTHS AND THEIR press indicators until the reliable
INTERNAL PRESSURE EFFECT ON THE fusing achieved.
AND HEAT FUSING APPLICATIONS
HOMOGENITY OF WASHING AND HEAT
PRESS HARDLY FUSING CLOTHS SHRINKAGE OF CLOTHS

• Compress the cloth and the fusi- In textile production, the usage of All SNT products passed through
ble interlining, cut in 5 cm stripes, various chemical ingredients and sanfor machines. For this reason,
simultaneously, to be fused at the their application methods, at the washing shrinkage after 10 wash-
left, right and middle parts of the stages of the cloth production, re- es is 1.5 % of meter. Heat shrink-
press and check if any differenc- sults in big functional differences age after pressing is 0.6%.
es occur in their dismantlement between cloth qualities. Because Due to the different fabric faces,
strengths. The dismantlement of this reason, there are even sig- it is recommended that fabrics
strength should be minimum nificant differences between cloth would be tested before the mass
1.2 Kg. qualities which have the same ap- use. Washing shrinkage must
• Compress the shirt collar, in pearance. For example, the sili- be max. 2%. If heat shrinkage is
parallel to blanket’s flowing di- cone based chemical coats, used more than 0.6% , cloth should
rection. Check the dismantlement for softening of the cloth, during be press alone. In this way, heat
strength. If there is strength dif- finishing process, affects its liq- shrinkage could be avoided and
ference between the sides, com- uid transfer ability negatively. It wetness of cloths is dehumidified.
press once more while turning the could be understood whether a The top fuse should be applied af-
left and right sides upside down cloth has a silicone finish, or not, ter this process.